![]() 4513313K ROOF MOLDINGS (2) END OF THE ROOF. Using a hacksaw, cut each roof molding according to the dimensions shown. Low-profile, aerodynamic crossbars strap to your vehicle's raised, factory side rails to create a super-strong and ultra-quiet roof rack. Remove the six clips from the roof channels. Thule Roof Rack - 2009 Honda Ridgelinewith factory installed raised rails that run front to back. Slide up the end of the roof molding and remove the roof molding. Read more Rhino-Rack 2500 Series Rack System customer reviews. Using the appropriate trim tool, pry up on the front of each roof molding. Also it would be nice if you sold the accessories that go in the channels tiedowns for LATTER RACKS they have other things called loops! I would highly recommend these racks to anyone they look very sleek and I like that they lock! Must take care by tightening each side slowly everything must stay even on the roof I’ve had to re-position one I did not use the specs because it just didn’t make any sense where the racks were located, good luck everyone. I am missing the rubber strips on the top of the racks that go in the channels they did not come with any of my rhino RACKS it’s kind of disappointing because it shows it in the picture and it shows it even in every video that I’ve seen out there other than that not bad I will be calling you on the phone to try to get these to myself so I don’t have to buy them individually they’re not very expensive! I believe they called vortex strips I need four of them again they go on the top of the rack I ordered two sets of racks yes they look wonderful except this one flaw.
0 Comments
Leave a Reply. |